Revel Salon User Manual download pdf (Page 7)

Figure 4. A REVEL ULTIMA

STUDIO with its inner

packing materials.

Figure 5. Installing the

optional top grille.

7. Remove top end pad, fabric sock, and plastic bag from the grille,

using caution to avoid touching the front tweeter or midrange.

8. Remove enclosed hardware and optional top grille (if present)

from recessed pockets in the top end pad. Install the top grille,

as shown in Figure 5.

9. Repeat steps 1 through 8 for the other loudspeaker.

NOTE: We recommend installing spikes after determining final

speaker placement (see discussion starting on next page).

After unpacking both units, carefully inspect each one for possible

damage due to shipping. If you discover any damage, immediately

contact your Revel dealer for further assistance. To move an

unpacked REVEL ULTIMA STUDIO (e.g., when experimenting

with placement), rock it side-to-side into place, using caution to

avoid touching the front tweeter and midrange.

Keep all packing materials for future shipping. In the unlikely

event a product will need repair, Revel will only accept a unit in its

original shipping carton. Using any other packing materials may

result in damage to the product and is not covered by the warranty.

See Service Information on page 23 for additional details.

REVEL ULTIMA STUDIO

Owner’s Manual

Top

Grille

Magnets

(in cabinet)

Top End Pad

Hardware

Top Grille

(if present)

Foam Strip

(1of 4)

Bottom

Rear End Pad

Bottom

Front End Pad

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Revel Salon User Manual Page 7