Revel W990 User Manual download pdf (Page 7)

In-Wall Architectural Loudspeaker

Instruction Manual

5. Make sure that all of the mounting frame’s spring-loaded clamps are

in their fully-extended positions. Loosen any clamp screws as required

to fully extend all of the clamps.

All Clamps

Fully Extended

6. Use both hands to snap the mounting frame into the mounting

opening.

Use Both Hands to Insert Frame

Straight Into Mounting Opening

7. Insert the supplied Frame Alignment Tool horizontally across the

frame. This tool prevents the frame from warping while you tighten

the clamps.

Insert

Alignment

Tool Into

Frame

8. Starting from the lower right corner and working in a diagonal torque

sequence, use a power screwdriver to tighten each of the clamp

screws only until almost snug. If necessary, adjust the mounting

frame while you tighten the screws so it remains level and centered

in the opening.

Tighten

Clamp Screws

9. Securely hand-tighten all of the clamp screws all the way and double-

check each screw to make sure it is fully tightened to prevent rattles.

Remove the Frame Alignment Tool.

10. Bring the speaker wire out through the mounting opening and

connect it to the speaker bafﬂe assembly as explained in Making

Connections, on page 6.

11. Slide the speaker bafﬂe assembly into place in the mounting frame.

Insert and ﬁnger-tighten the four screws you removed in step 4 into

the holes in the bafﬂe.

NOTE: To prevent buzzing, make sure that the speaker wire is not

touching the woofer cone.

1 2 3 4 5 6 7 8 9

No comments

Revel W990 User Manual Page 7